| If you want to keep your stemmed wine | | | | to get a nail or screw, a screwdriver and a |
| glassware from breaking, and don't have much | | | | hammer. You figure out where each of the |
| space to spare, you might consider purchasing an | | | | screws go, double-check that you're right, then |
| under cabinet wine glass rack. | | | | tap the nail about 1/8" into the wood at the point |
| The Wine Enthusiast Hanging Metal Stemware | | | | you marked with a pencil. Then you, preferably, |
| Rack, which is an inexpensive wire rack that | | | | drill a hole with a drill bit that's a tiny bit smaller |
| mounts underneath the top board on a cabinet, | | | | than the inside shank of the screw. |
| helps more fully utilize cabinet space, and at the | | | | You can make sure it doesn't poke all the way |
| same time keep you having to utilize ceiling or wall | | | | through the top of the cabinet's board by |
| space. This chrome stemware rack holds eighteen | | | | wrapping a piece of masking tape around the drill |
| wine stems. Many different kinds of wine-stem | | | | with the top of the masking tape at the |
| glass racks are mounted underneath the top | | | | measurement of depth of the screw. When your |
| board of a cabinet. With most racks that need to | | | | drill hits the masking tape line, it's deep enough. |
| be mounted in such a way, they tend to give you | | | | Ensure that the length of the screw won't go |
| a printed paper template which allows you to | | | | through the top of the cabinet. If you don't have |
| puncture through X's which lets you know where | | | | a drill, then rub the screw across some dry soap. |
| to drive the screws. It measures 25-1/2" wide by | | | | Then use a screwdriver and some force with |
| 10" deep by 1-1/2" high. | | | | your arm to shove upwards as you turn. The |
| You'll also need to determine where the screw | | | | screw will enter the wood and the soap will allow |
| holes are to be put. If they've given you a | | | | you to drive the screw in without any pilot hole. |
| template, then use it to install the rack. You'll have | | | | |